Samsung Smart Signage URL Setup Guide


Although the SSSP displays use a web browser to display the content, it is not possible for a user to launch the browser using the IR remote. This is specifically configured to prevent unwanted changes to the content that is shown while the device is running. Instead, we have provided a way to enter the URL using a factory menu*.

*Note: The factory menu is a hidden menu that provides direct control over system and hardware level settings. Do not change any settings in the factory menu other than what is described in this document. Changing the wrong settings could make the device unuseable.

Accessing the Factory Menu

Use the following instructions to enter the URL to your content:

Step 1: 

Make sure the SSSP Professional Display’s power cable is connected to an appropriate power source.

Step 2:

If the display is “on” (currently showing something on-screen), use the IR remote to turn it off by pressing the “Off” button on the remote.

Step 3:

Press the following key sequence using the IR remote. (It must be this exact sequence. If any other buttons are pressed, you will need to start over).

Mute + 1 + 8 + 2 + Power On

Step 4:

Wait a few seconds. The SSSP device should boot directly into the factory menu.

Step 5:

Select the “Control” option.

Step 6:

Select the “LFD Option” option.

Step 7:

Select the “LFD Launcher” option.

Step 8:

Select the “Launcher Mode” setting and change it to “ON”.

Step 9:

Select the “Server URL Setting” option.

Step 10:

Enter the URL to your content.

( Example: )

Step 11:

Select the “Done” button to save the URL.

Step 12:

Reboot the display by turning the power off using the “off” button on the remote, waiting 4 or 5 seconds, and then turning the display back on using the “power on” button on the remote.

Feedback and Knowledge Base